Floorheating Direct Underfloor Heating Mat 2.5 mē 375 Watts & Thermostat

Floorheating Direct Underfloor Heating Mat
2.5m² - 375 Watts (500mm x 5m) & Digital Thermostat

 

An advanced heating form designed to be easily fitted below a tiled floor, allowing you to walk comfortably on its usually cold surface. Used in conjunction with our comfort digital thermostat you can comfortably control that room to your preferred taste with economy.

It is primarily designed for use on concrete floors but can be easily installed on a wooden sub floor by either using a tile backing board or a thin screed of flexible tile adhesive.

Kit Contents

Self Adhesive Heating Mat, Instruction Booklet, 10mm Conduit Pipe, Digital Thermostat

Bathroom Wetroom Kitchen Conservatory Lounge Office Lobby Hallway	Tiles Stone Marble Slate	Economically Warms the entire surface of the Tiled Floor Easy Quick Installation - mesh and cable are pre-fitted then self adhere to the floor Primary or Comfort Heating*** Fit it and Forget it

Slightly Confused ? Need some Help? Just call our UK Support line: 0870 850 6704

Specifications

The Comfort Mat System is constructed of a tough open nylon mat with an integral conductor and resistance cable. It is only 3.5mm thick and well able to withstand tough installations and is installed directly within the flexible tile adhesive.

The insulation covering of the heating element is made from TEFLON and the external covering is woven wire braid with a further PVC sheath making it very durable and 100% waterproof

• EMC-free, twin conductor cable with 3.5 meter 3-core power cable, attached to glass fibre mat.
• 375 watts 
• 1.6 amps
• 500mm wide x 5 m lengh
• The cable insulation under the external braid fully covers the cable
• Strong Teflon coated cable with a PVC outer sheath
• 11 watts per linear meter - 230/240 Volt.
• Tested to between 4000 and 10.000 volts
• Cable diameter approx 3.5mm
• Mat width – 500mm
• ISO 9001 certified producer
• CE/KEMA Certified
• 10 year guarantee

Please Note

 

The heating cable cannot be cut, however the mesh it is mounted on may be cut and shaped to suit

 

For the best results we always recommend installing the mat on an insulated sub floor or thermal board

 

A Heat Loss calculation is always recommended to determine whether the system can be used as a primary heat source